From Fedora Project Wiki

< QA‎ | TestCases

(→‎Steps To Reproduce: rephrase second step to explicitly reuse the existing array)
Line 1: Line 1:
= PartitioningPreExistingRaidRaid =
+
{{QA/Test_Case
== Description ==
+
|description=A complete installation using a RAID device for the / (rootfs) filesystem.  The previous state of the disk partitions should contain a legacy RAID installation.
A complete installation using a RAID device for the / (rootfs) filesystem.  The previous state of the disk partitions should contain a legacy RAID installation.
+
|actions=
 
 
== Steps To Reproduce ==
 
 
 
 
# Perform a manual install, using RAID during partitioning (the initial, legacy system)
 
# Perform a manual install, using RAID during partitioning (the initial, legacy system)
 
# Perform a second manual install, reusing the existing array.
 
# Perform a second manual install, reusing the existing array.
 
+
|results=
== Expected Results ==
 
 
 
 
# Anaconda completes successfully
 
# Anaconda completes successfully
 
# Reboot successfully into installed system
 
# Reboot successfully into installed system
 
# / is on a RAID volume (e.g. /dev/md0)
 
# / is on a RAID volume (e.g. /dev/md0)
 +
}}
 +
  
 
[[Category:Installer Test Cases|PartitioningPreExistingRaidRaid]]
 
[[Category:Installer Test Cases|PartitioningPreExistingRaidRaid]]

Revision as of 08:09, 15 December 2009

Description

A complete installation using a RAID device for the / (rootfs) filesystem. The previous state of the disk partitions should contain a legacy RAID installation.


How to test

  1. Perform a manual install, using RAID during partitioning (the initial, legacy system)
  2. Perform a second manual install, reusing the existing array.

Expected Results

  1. Anaconda completes successfully
  2. Reboot successfully into installed system
  3. / is on a RAID volume (e.g. /dev/md0)