QA:Testcase Dracut root=partition

Description

This test case is intended to validate dracut's ability to locate the root device when booting with root=/dev/device. Note, this test case may require a fresh installation to prepare the system.

How to test

1. Start with a system where the root device that does not exist on an encrypted partition, a logical volume, or a RAID device. You may determine your current root device by inspecting the boot arguments provided to your system in /proc/cmdline. If uncertain, you may install a system following the instructions in QA:Testcases_anaconda_ext4_rootfs_on_disk_partition or QA:Testcases_anaconda_ext3_rootfs_on_disk_partition
2. After install, confirm that your system is using a dracut-enabled initial ramdisk. If the kernel rpm provides a ramdisk image you likely have a host-built dracut initial ramdisk. The following example shows a system with a host-built dracut-enabled initial ramdisk.

   # rpm -ql kernel-$(uname -r) | grep "/boot/initrd.*\.img"

   /boot/initrd-2.6.31-0.174.rc7.git2.fc12.i686.img

   /boot/initrd-generic-2.6.31-0.174.rc7.git2.fc12.i686.img

3. If no dracut-enabled initial ramdisk is found on your system, follow instructions at QA:Testcase Dracut switch to locally built ramdisk
4. Create a new boot entry to use for this test.

   # grubby --make-default --title "dracut-test" \

   --add-kernel /boot/vmlinuz-$(uname -r) \

   --initrd /boot/initrd-generic-$(uname -r).img \

   --copy-default

5. Determine the UUID used to reference your root (/) filesystem from the file /etc/fstab. Using the example below, the UUID desired is the second line (UUID=6cad5605-1484-47a5-ae77-ba50b0556ee1).

   # cat /etc/fstab

   UUID=b18b0301-5dba-4665-b379-b8d838e24cee /boot ext3 defaults 1 2

   UUID=6cad5605-1484-47a5-ae77-ba50b0556ee1 / ext3 defaults 1 1

   UUID=83c52ae6-f052-4812-9f9d-a8963e0d925f swap swap defaults 0 0

   tmpfs /dev/shm tmpfs defaults 0 0

   devpts /dev/pts devpts defaults 0 0

   sysfs /sys sysfs defaults 0 0

   proc /proc proc defaults 0 0

6. Using the UUID, determine the block device using the command blkid -l -t UUID=. For example:

   # blkid -l -t UUID=6cad5605-1484-47a5-ae77-ba50b0556ee1

   /dev/vda2: UUID="6cad5605-1484-47a5-ae77-ba50b0556ee1" TYPE="ext3" SEC_TYPE="ext2"

7. Now edit /etc/grub.conf, locate the boot entry created earlier titled dracut-test, and change root=UUID=6cad5605-1484-47a5-ae77-ba50b0556ee1 to match the block device noted above. In this example, use root=/dev/vda2
8. Now reboot the system

Expected Results

1. The system boots normally.