From Fedora Project Wiki

(revise to use template, clean a bit)
Line 5: Line 5:
 
|actions=
 
|actions=
 
{{Template:partitioning_actions}}
 
{{Template:partitioning_actions}}
# Ensure only the single target device you prepared is selected as the installation target disk.
+
{{Template:Partitioning_single_custom_blank}}
# Ensure the option to configure partitioning yourself is selected,and complete this screen.
 
# On the ''MANUAL PARTITIONING'' screen, delete all existing partitions (if any).
 
 
# Click the ''Click here to create them automatically'' link
 
# Click the ''Click here to create them automatically'' link
# delete swap partition,and click ''Done'' twice
+
# Delete the swap partition that is automatically created
 
{{Template:partitioning_actions_post}}
 
{{Template:partitioning_actions_post}}
 
|results=
 
|results=
 
{{Template:partitioning_results}}
 
{{Template:partitioning_results}}
# Anaconda warns that system performance may suffer without a swap partition
+
# Anaconda should warn that system performance may suffer without a swap partition
# Anaconda allows the installation to complete successfully for systems with sufficient system memory (consult the [http://docs.fedoraproject.org/en-US/Fedora/16/html/Release_Notes/sect- Release_Notes-Welcome_to_Fedora_16.html#sect-Release_Notes-Hardware_Overview Hardware Overview section of the release notes] for minimum hardware requirements). For systems with insufficient memory, anaconda must require the presence of a {{filename|swap}} partition.
+
# Anaconda should allow the installation to complete successfully for systems with sufficient system memory. For systems with insufficient memory, anaconda must require the presence of a {{filename|swap}} partition.
# Reboot successfully into installed system
+
# No swap partition should be in use (you can check {{filename|/proc/swaps}})
# Confirm that no swap partition is in use ({{filename|/proc/swaps}})
 
 
}}
 
}}
  
 
[[Category:Installer Partitioning Test Cases]]
 
[[Category:Installer Partitioning Test Cases]]

Revision as of 22:49, 20 January 2015

Description

An installation without specifying a swap partition. When a system has sufficient memory, the installer should warn, but not restrict this request.

Setup

  1. Prepare a test system with a working, supported storage device of sufficient size for a Fedora install, and a Fedora installation medium.

How to test

  1. Boot the installer using any available means.
  2. Proceed to the installer's main screen, making sensible choices, and enter the Installation Destination screen.
  3. Ensure only the single target device you prepared is selected as the installation target disk.
  4. Ensure the Custom option is selected under Storage Configuration, and complete this screen.
  5. On the MANUAL PARTITIONING screen, delete all existing partitions (if any).
  6. Click the Click here to create them automatically link
  7. Delete the swap partition that is automatically created
  8. Complete the installation process, making sensible selections for all other installer options.
  9. Boot the installed system.

Expected Results

  1. The expected partition layout should be created on the target device(s).
  2. The install process should complete successfully and the installed system should boot as expected.
  3. Anaconda should warn that system performance may suffer without a swap partition
  4. Anaconda should allow the installation to complete successfully for systems with sufficient system memory. For systems with insufficient memory, anaconda must require the presence of a swap partition.
  5. No swap partition should be in use (you can check /proc/swaps)