From Fedora Project Wiki

(clean up)
(gnome-screensaver is broken, use xset to force DPMS instead)
Line 5: Line 5:
# Ensure the file /etc/X11/xorg.conf does not exist, or is a known-good configuration file that uses the 'radeon' driver
# Ensure the file /etc/X11/xorg.conf does not exist, or is a known-good configuration file that uses the 'radeon' driver
# Shut your system down entirely, then start it up again
# Shut your system down entirely, then start it up again
# Run <tt>gnome-screensaver-preferences</tt>
# Run <tt>sleep 5 && xset dpms force off</tt>
# Select a screensaver, set the "Regard the computer as idle after:" timeout to one minute, and ensure 'Activate screensaver when computer is idle' is checked
# Click 'Power Management', and set the 'Put display to sleep when inactive for:' timeout to the minimum (six minutes)
# Leave the system idle for longer than six minutes
|results=
|results=
# The screensaver should activate after a minute, and the display should blank after six. It should recover correctly when the mouse is moved
# After 5 seconds the display should blank. It should recover correctly when the mouse is moved
}}
}}
[[Category:Radeon_Test_Cases]]
[[Category:Radeon_Test_Cases]]

Revision as of 14:58, 1 April 2009

Description

This test case tests whether screen saver and DPMS work successfully with the Radeon video driver, with kernel mode setting enabled. You must be using a card supported by the Radeon video driver.


How to test

  1. Ensure the 'nomodeset' kernel parameter is not enabled in your bootloader configuration (unless you need it for basic X operation to suceed)
  2. Ensure the file /etc/X11/xorg.conf does not exist, or is a known-good configuration file that uses the 'radeon' driver
  3. Shut your system down entirely, then start it up again
  4. Run sleep 5 && xset dpms force off

Expected Results

  1. After 5 seconds the display should blank. It should recover correctly when the mouse is moved