From Fedora Project Wiki
m |
|||
| Line 1: | Line 1: | ||
= Description = | = Description = | ||
| − | This is the test case to check if runtime changes of firewall zones are usable. | + | This is the test case to check if '''runtime''' changes of firewall zones are usable. |
| − | Settings in the zone done with firewall-cmd (without --permanent switch) are only valid till reboot or firewalld service restart. | + | Settings in the zone done with ''firewall-cmd'' (without ''--permanent'' switch) are only valid till reboot or firewalld service restart. |
= How to test = | = How to test = | ||
| − | Get settings of 'work' zone | + | Get settings of ''work'' zone |
firewall-cmd --zone=work --list-all | firewall-cmd --zone=work --list-all | ||
| − | Enable service 'samba-client' in zone 'work' | + | Enable service ''samba-client'' in zone ''work'' |
firewall-cmd --zone=work --add-service=samba-client | firewall-cmd --zone=work --add-service=samba-client | ||
| Line 28: | Line 28: | ||
firewall-cmd --zone=work --list-services | firewall-cmd --zone=work --list-services | ||
| − | should contain samba-client. | + | should contain ''samba-client''. |
Now undo the previous change. | Now undo the previous change. | ||
| Line 43: | Line 43: | ||
firewall-cmd --zone=work --list-all | firewall-cmd --zone=work --list-all | ||
| − | should now show the same output as for the first time, i.e. no samba-client. | + | should now show the same output as for the first time, i.e. no ''samba-client''. |
Revision as of 10:20, 27 September 2012
Description
This is the test case to check if runtime changes of firewall zones are usable.
Settings in the zone done with firewall-cmd (without --permanent switch) are only valid till reboot or firewalld service restart.
How to test
Get settings of work zone
firewall-cmd --zone=work --list-all
Enable service samba-client in zone work
firewall-cmd --zone=work --add-service=samba-client
To check (as root) if it has been enabled:
iptables-save | grep work
These two lines should be in the output:
-A IN_ZONE_work_allow -p udp -m udp --dport 137 -j ACCEPT -A IN_ZONE_work_allow -p udp -m udp --dport 138 -j ACCEPT
And
firewall-cmd --zone=work --list-services
should contain samba-client.
Now undo the previous change. You can either manually remove the service
firewall-cmd --zone=work --remove-service=samba-client
or just restart firewalld,
service firewalld restart
because the change we did has not been permanent.
firewall-cmd --zone=work --list-all
should now show the same output as for the first time, i.e. no samba-client.