From Fedora Project Wiki

m (improve instructions)
(merge Anaconda_User_Interface_VNC_Password)
Line 3: Line 3:
|setup=
|setup=
# Prepare any non-live media for booting the installer (anything except {{filename|Live.iso}})
# Prepare any non-live media for booting the installer (anything except {{filename|Live.iso}})
# Install a VNC viewer, e.g. {{package|vinagre}} or {{package|tigervnc}}.
|actions=
|actions=
<ol>
<ol>
<li>In the initial boot menu screen, append <code>inst.vnc</code> boot option and boot the installer</li>
<li>In the initial boot menu screen, append <code>inst.vnc</code> boot option and boot the installer
<li>Watch the text messages printed out, you should see something like this:
<ul>
<li>Optionally, you can also add <code>inst.vncpassword=<password></code> boot option to encrypt the VNC connection.</li>
</ul>
</li>
<li>The installer prints out a message similar to this (depending whether you provided the password or not) and waits:
<pre>
<pre>
09:12:24 Starting VNC...
09:12:24 Starting VNC...
Line 29: Line 34:
|results=
|results=
# The installer starts the VNC server and prints out information how to connect to it
# The installer starts the VNC server and prints out information how to connect to it
# User can connect with a VNC client and see graphical installation
# You can connect with a VNC client and see the graphical installation
#* If the VNC connection was encrypted, you are asked for a password. Providing correct password unlocks the session, incorrect passwords are rejected. If the connection was not encrypted, no password is necessary.
# The installer displays and works properly
# The installer displays and works properly
# The installation completes successfully
# The installation completes successfully

Revision as of 15:40, 12 November 2012

Description

This is to verify that Anaconda can perform an installation over the VNC remote desktop protocol

Setup

  1. Prepare any non-live media for booting the installer (anything except Live.iso)
  2. Install a VNC viewer, e.g. vinagre or tigervnc.

How to test

  1. In the initial boot menu screen, append inst.vnc boot option and boot the installer
    • Optionally, you can also add inst.vncpassword=<password> boot option to encrypt the VNC connection.
  2. The installer prints out a message similar to this (depending whether you provided the password or not) and waits:
    09:12:24 Starting VNC...
    09:12:25 The VNC server is now running.
    09:12:25 
    
    WARNING!!! VNC server running with NO PASSWORD!
    You can use the vncpassword=<password> boot option
    if you would like to secure the server.
    
    09:12:25 Please manually connect your vnc client to 192.168.1.17:1 to begin the install.
    
  3. Connect with a VNC client (vncviewer, vinagre) to the specified address, you should see the graphical installation:
    vinagre 192.168.1.17:1
    
  4. Proceed and complete the installation with the VNC client.
  5. Boot the new system and check it starts in the text mode (runlevel 3):
    $ runlevel 
    N 3

Expected Results

  1. The installer starts the VNC server and prints out information how to connect to it
  2. You can connect with a VNC client and see the graphical installation
    • If the VNC connection was encrypted, you are asked for a password. Providing correct password unlocks the session, incorrect passwords are rejected. If the connection was not encrypted, no password is necessary.
  3. The installer displays and works properly
  4. The installation completes successfully
  5. The installed system boots into runlevel 3 (text mode)