From Fedora Project Wiki

< QA‎ | TestCases

m (Added category)
(Per ticket#47, marking as obsolete)
 
(5 intermediate revisions by 4 users not shown)
Line 1: Line 1:
= PartitioningPreExistingRaidRaid =
+
{{QA/Test_Case
== Description ==
+
|description=A complete installation using a RAID device for the / (rootfs) filesystem.  The previous state of the disk partitions should contain a legacy RAID installation.
A complete installation using a RAID device for the / (rootfs) filesystem.  The previous state of the disk partitions should contain a legacy RAID installation.
+
|actions=
 +
# Perform a manual install, using RAID during partitioning (the initial, legacy system)
 +
# Perform a second manual install, reusing the existing array.
 +
|results=
 +
# Anaconda completes successfully
 +
# Reboot successfully into installed system
 +
# / is on a RAID volume (e.g. /dev/md0)
 +
}}
  
== Steps To Reproduce ==
+
[[Category:Installer Partitioning Test Cases]]
 
+
[[Category:Obsolete_Test_Cases]]
* Perform a manual install, using RAID during partitioning (the initial, legacy system)
 
 
 
* Then perform a second manual install, using RAID during partitioning that utilizes
 
the previous partition setup.
 
 
 
 
 
== Expected Results ==
 
 
 
 
 
1. Anaconda completes successfully
 
 
 
1. Reboot successfully into installed system
 
 
 
1. / is on a RAID volume (e.g. /dev/md0)
 
 
 
[[Category:Installer Test Cases|PartitioningPreExistingRaidRaid]]
 

Latest revision as of 18:35, 26 January 2010

Description

A complete installation using a RAID device for the / (rootfs) filesystem. The previous state of the disk partitions should contain a legacy RAID installation.


How to test

  1. Perform a manual install, using RAID during partitioning (the initial, legacy system)
  2. Perform a second manual install, reusing the existing array.

Expected Results

  1. Anaconda completes successfully
  2. Reboot successfully into installed system
  3. / is on a RAID volume (e.g. /dev/md0)