From Fedora Project Wiki
(Created page with '{{QA/Test_Case |description=This test case measures energy consumed by you system while in active idle with throughput-performance profile activated. {{admon/note|This test targ...') |
No edit summary |
||
| Line 1: | Line 1: | ||
{{QA/Test_Case | {{QA/Test_Case | ||
|description=This test case measures energy consumed by you system while in active idle with throughput-performance profile activated. | |description=This test case measures energy consumed by you system while in active idle with throughput-performance profile activated. | ||
{{admon/note|This test targets laptop users. It will take approx. 15 minutes. If you do not have laptop or enough time feel free to skip this test. In this case please leave the corresponding column in the results table blank.}} | {{admon/note|This test targets laptop users. It will take approx. 15 minutes. If you do not have laptop or enough time feel free to skip this test. In this case please leave the corresponding column in the results table blank. If you complete this test, please also complete the [[QA:Testcase_Power_Management_tuned_powersave_idle]].}} | ||
|setup= | |setup= | ||
# Check that you have ''pm-test-day'' package installed: | # Check that you have ''pm-test-day'' package installed: | ||
| Line 12: | Line 12: | ||
|results= | |results= | ||
# Energy consumed during the test is written | # Energy consumed during the test is written to the stdout. | ||
}} | }} | ||
[[Category:Power_Management_Test_Cases]] | [[Category:Power_Management_Test_Cases]] | ||
Revision as of 00:10, 20 March 2011
Description
This test case measures energy consumed by you system while in active idle with throughput-performance profile activated.
This test targets laptop users. It will take approx. 15 minutes. If you do not have laptop or enough time feel free to skip this test. In this case please leave the corresponding column in the results table blank. If you complete this test, please also complete the QA:Testcase_Power_Management_tuned_powersave_idle.
Setup
- Check that you have pm-test-day package installed:
$ rpm -q pm-test-day
How to test
- Run the following command:
# measure_performance_idle
- Do not touch your computer until the test completes (cca. 15 minutes).
- Write the output to the results table.
Expected Results
- Energy consumed during the test is written to the stdout.