|
|
| (10 intermediate revisions by one other user not shown) |
| Line 1: |
Line 1: |
| {{QA/Test_Case
| | This is a dead page. Use https://fedoraproject.org/wiki/QA:Testcase_CoreOS_swap_on_zram instead. |
| |description=Install and validate Fedora CoreOS with swap on zram enabled
| |
| |setup=
| |
| # Download and verify the latest [https://getfedora.org/coreos/download?tab=metal_virtualized&stream=next FCOS <b>next</b> image] (pick the right image for your environment).
| |
| # Read background on zram [https://www.fedoraproject.org/wiki/Changes/SwapOnZRAM here].
| |
| # Figure out how you'd like to configure your initial zram device.
| |
| # Read other possible post-boot tests as described [https://fedoraproject.org/wiki/QA:Testcase_SwapOnZRAM_customconfig here].
| |
| | |
| |actions=
| |
| # [https://docs.fedoraproject.org/en-US/fedora-coreos/producing-ign/ Create an Ignition file].
| |
| # Configure Zram device validating instructions [https://docs.fedoraproject.org/en-US/fedora-coreos/sysconfig-configure-swaponzram/ here].
| |
| # Launch your Fedora CoreOS system using this Ignition file. See [https://docs.fedoraproject.org/en-US/fedora-coreos/getting-started/#_quickstart the Quickstart] and the provisioning docs for a guide how to launch FCOS in most environments (bare metal, virtual, cloud, etc).
| |
| | |
| |results=
| |
| # You can SSH successfully into your FCOS system.
| |
| # Verify the swap device is set up by viewing the swapon --show output. You can also view the true compression ratio of the currently configured zram devices by running zramctl.
| |
| # The linked documentation makes sense, nothing is obviously missing, and the instructions are clear.
| |
| }}
| |
| | |
| [[Category:CoreOS Test Cases]]
| |
Latest revision as of 16:16, 5 April 2022
